Does the AR-9 Ejector need to be glued in?

Category: Assembly

Short answer, no. Long answer, it won’t hurt until you need to replace or remove the ejector. On my AR-9 designs the ejector is 3D printed, it presses into a pocket on the lower. This may be concerning to some users, as it appears to only be a friction fit holding the part in. However, if you look closely you will see that the upper receiver holds down the edge of the ejector when the upper is installed, this locks the ejector in place so that it can not escape. I do not recommend glue.

Leave a Reply

Your email address will not be published. Required fields are marked *

Shopping Cart
Scroll to Top